HAKKO FR-810B Hot Air Station European Version, Temperature and Air Flow Digital Regulation
NEW HAKKO FR-810B Hot Air Station European Version
High power and large air volume
Further evolution of SMD rework station
High power and large volume hot air for quick removal of components
A tool that can provide powerful hot airflow for repairing high heat capacity circuit boards that require high blow volume and high output, and sufficient hot airflow for appropriate blow volume and high output for high-density mounting substrates.
The FR-810B’s high volume airflow and high output make it possible to perform the same work in only one-third of the time required when using a conventional model. This reduces the thermal impact on boards and components.
Examination of time taken for connector sections soldered onto a ceramic board to be heated to 200°C with maximum temperature and airflow settings selected.
* Single nozzles with an approximately 4mm diameter were used.
Improvements of FR-810B
On top of the features of FR-810, high power and large air volume, the new functions of vacuum pickup and pickup indicator have been given to FR-810B.
The 2 new functions make it possible to remove a component without damaging PWB.
- New type of nozzles for improvement of temperature characteristics
The new nozzle improves work efficiency with uniform heating by hot air convection inside the nozzle which is created due to vents on the nozzle top. (Only with BGA nozzle)
- Vacuum pickup function
The vacuum pickup function is to pick up a component with a suction pad and vacuum. It will pick a component only after the hot air melts solder joints.
This can avoid an error to peel off the land by removing a component with excessive force.
- Pickup indicator
By pre-setting pickup function, a component can be picked up automatically when solder is melted. Then, the indication comes up and the moment of picking up will be visible. Even a component and solder joints can not be seen as covered by a nozzle, easy and safe picking up is possible.
Temperature and Air Flow Digital Regulation
- European input Voltage 220/240V
- New type of nozzle can be replaced with a single-touch
- Pre-Set mode allows creating simple profile
- Sleep function
- the unit comes with 4mm nozzle as standard (HAKKO N51-02)
- HAKKO FR-810B station
- handpiece holder
- FP pick up
- heat resistant pad
- power cord european plug
- nozzle 4mm diameter
- 2 x sucker (Φ3mm, Φ5mm, Φ7.6mm)
- instruction manual
- European input Voltage 220/240V
- Temperature range: 50 – 600°C
- Air flow: 5-50 L/min with 4mm nozzle (HAKKO N51-02)
- Station outer dimension: 160x145x220mm
- Weight: 1.3Kg approx
- Handpiece total lenght without nozzle: 220mm
- Handpiece weight: 180g
The current nozzles can be attached to the FR-810B with the new nozzle adapter which is option part.
When FR-810B is fixed on rework fixture (HAKKO C1392B), the adapter is required due to smaller diameter of FR-810B handle comparing with FR-801/FR-802/FR-803B.
Preset mode allows you to change the settings easily to suit a variety of boards and workpieces. You can program temperature, time and airflow settings for up to five presets.
Simply switch to the desired setting for variety of jobs.
The chain presets allows you to create a simple temperature profile by combining settings in preset mode. Up to five steps can be created.
It also supports sophisticated removal work, and significantly improves efficency.
Auto Sleep and Auto Shutoff Features
To ensure safety and conserve power, when the handpiece is placed in the handpiece holder, the auto sleep function is activated and it starts cooling automatically.
If the handpiece has not been removed from the handpiece holder (ex. using the rework fixture= and after it has been idle for 30 minutes, auto shutoff function is activated. It is automatically powered off.
Access to settings can be restricted via the password function for easy management.